Sony MZ-N10 - Manual (Page 19)

19
3 Verify that the charge lamp lights up.
• If the charge lamp turns off after a
short time:
This means the built-in rechargeable battery is
sufficiently charged (the battery is charged
when shipped).
• If a time display (“-- min”) appears:
This is the remaining charging time. It usually
takes about one hour to sufficiently charge a
completely drained battery. At the point the
charge lamp goes off, the battery is about 80%
charged. After 3 more hours, the battery will
be fully charged.
4 Press RELEASE to remove the recorder
from the USB cradle.
z
• Display changes as follows:
“Charging”, “-- min”
t “Charging”, “65 min” (65 minutes to end of charging) t “Charging”, “64
min” t ...t No display
• Operations can be done on the recorder or the remote control while charging. However, the remaining
charging time will not be displayed during this time.
For models supplied with the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
charge lamp
“Charging” and
“-- min” appear
when charging
starts.
RELEASE
1
2
4
3
When operating the recorder for an extended length of time using the alkaline
dry battery together with the built-in rechargeable battery
2 Attach the dry battery case to the recorder. 3 Insert a LR6 (size AA) alkaline dry
battery.
Insert the battery minus end first. Rear of the
recorder
1 Charge the built-in rechargeable battery.
The recorder cannot be used with a dry battery if the power of the built-in rechargeable battery
is low. If “LOW BATT” appears in the display, charge the rechargeable battery.
continued