Sharp R-2397 - Manual (Page 3)

1
R-2397
SERVICE MANUAL
SHARP CORPORATION
OSAKA, JAPAN
COMMERCIAL
R-2397
GENERAL IMPORTANT INFORMATION
This Manual has been prepared to provide Sharp Corp. Service
engineers with Operation and Service Information.
It is recommended that service engineers carefully study the
entire text of this manual, so they will be qualified to render
satisfactory customer service.
CAUTION
MICROWAVE RADIATION
DO NOT BECOME EXPOSED TO RADIATION FROM
THE MICROWAVE GENERATOR OR OTHER PARTS
CONDUCTING MICROWAVE ENERGY.
Service engineers should not be exposed to the microwave
energy which may radiate from the magnetron or other
microwave generating devices if it is improperly used or
connected. All input and output microwave connections,
waveguides, flanges and gaskets must be secured. Never
operate the device without a microwave energy absorbing
load attached. Never look into an open waveguide or
antenna while the device is energized.
WARNING
Never operate the oven until the following points are ensured.
(A) The door is tightly closed.
(B) The door brackets and hinges are not defective.
(C) The door packing is not damaged.
(D) The door is not deformed or warped.
(E) There is not any other visible damage with the oven.
Servicing and repair work must be carried out only by trained
service engineers.
All the parts marked "*" on parts list are used at voltages more
than 250V.
Removal of the outer wrap gives access to potentials above
250V.
All the parts marked "
∆
" on parts list may cause undue
microwave exposure, by themselves, or when they are dam-
aged, loosened or removed.
PRODUCT SPECIFICATIONS
FUNCTION OF IMPORTANT
COMPONENTS
SERVICING AND
TROUBLESHOOTING CHART
TEST PROCEDURE
APPEARANCE VIEW
OPERATING SEQUENCE
GENERAL INFORMATION
MICROWAVE MEASUREMENT
COMPONENT
REPLACEMENT AND
ADJUSTMENT PROCEDURE
TOUCH CONTROL PANEL
ASSEMBLY
WIRING DIAGRAM
PARTS LIST