Sharp R-2397 User Manual
Page 10
8
R-2397
CONDITION
“ . “ does not appear on display when power
cord is plugged into wall outlet.
Control panel can not accept key in.
Fuse F6.3A blows when the door is opened.
Home fuse blowns when power cord is plugged
into wall outlet.
Weak point A017 blowns when power cord is
plugged into wall outlet.
Oven lamp, fan motor and stirrer motors do not
work for 1 minute whenever the door is opened
or after cooking.
Fuse F2 F6.3A blowns when power cord is
plugged into wall outlet.
Oven lamp does not light when door is opened.
(Blower and stirrer motors work)
Blower motor does not work when door is
opened. (Oven lamp lights and stirrer motors
work)
“EE 1” appear in display.
“EE 2” appear in display.
“EE 3” appear in display .
“EE 6” appear in display.
“EE 7” appear in display.
“EE 9” appear in display.
Oven lamp, blower motor and stirrer motors do
not work.
Oven lamp does not work.
Blower motor does not work.
Oven does not stop after end of cooking cycle or
when STOP/CLEAR key is touched. (Oven lamp,
blower motor and stirrer motors stop.)
Home fuse blows when starting the oven.
Oven goes into cook cycle but shuts down
before end of cooking cycle.
Oven seems to be operating but no heat is
produced in oven load.
It passed more than 1 minute after cooking but
oven lamp, blower motor and stirrer motors do
not stop.
“EE 0” appear in display .
“EE 16” appear in display.
“EE 17” appear in display.
“EE 8” appear in display .
“EE 10” appear in display .
Stirrer motors do not work.
PPROBLEM
TEST PROCEDURE
A
A
B
B
C
C
C
D
D
E
E
E
E
E
F
F
G
H
ON
CONDITION
OFF
CONDITION
MAGNETRON MG1
MAGNETRON MG2
HIGH VOLTAGE TRANSFORMER T1
HIGH VOLTAGE TRANSFORMER T2
H.V. RECTIFIER ASSEMBLY FOR MG1
H.V. RECTIFIER ASSEMBLY FOR MG2
H.V. WIRE HARNESS
H.V. CAPACITOR C1
H.V. CAPACITOR C2
1ST. LATCH SWITCH
2ND. LATCH SWITCH
3RD. LATCH SWITCH
MONITOR SWITCH
STOP SWITCH
WEAK POINT A018 F3
WEAK POINT A018 F4
WEAK POINT A017 F1
FUSE 6.3A F2
POSSIBLE CAUSE
AND
DEFECTIVE PARTS