Speco Technologies SIPMPBVFH - Manual (Page 42)

2-38
Parameters Description
Day/Night Mode
Select the day/night mode.
Auto: The camera would switch between day and night
mode automatically. It will follow Day to Night and Night
to Day threshold defined by user below.
Day: The camera will stay in day (Color) mode.
Night: The camera will stay in night (black & white)
mode.
Day/Night Type
Select the method used by Camera to determine
illumination level. It can be either CDS light sensor or
through image analysis by DSP. Not every model will
allow selection for this.
Switch from Day
mode to Night
mode
Check box to enable the B2 frame in RTP streaming
Switch if lasts
more than X
seconds
The camera will only switch day/night status if the
illumination level stays either above or below the
boundary for this much time. This is to prevent a
temporary brightness change from triggering unnecessary
day/night changes.
Switch from Night
mode into Day
Mode
This value controls the level of light where camera
switches into Day mode. Increasing it will make
camera switch to night mode at a darker illumination
level.
Switch if lasts
more than X
seconds
The camera will only switch day/night status if the
illumination level stays either above or below the
boundary for this much time. This is to prevent a
temporary brightness change from triggering unnecessary
day/night changes.
Day/Night IR LED
IR LED may be configured as AUTO or Disabled here. If
it is set as AUTO, LED will turn on in night mode and turn
off in day mode. If set to Disabled, LED will stay off when
camera switches into night mode.
Brightness Meter
Bar
This bar shows the illumination level at which cameras go
to night or day mode (Blue / Red bars), and shows the
current detected illumination level (Green bars). Use this
bar to fine tune the day/Night switch timing.
Get Current
Exposure Level
Clicking this button will refresh the illumination level
reading from the camera sensor. The larger the number, the
darker the environment.
Click the [Apply] button to confirm the settings or click the [Reset] button to
re-enter the parameters.