Speco Technologies SIPMPBVFH - Manual (Page 20)

2-16
2.3.2 Date & Time
This section tells you how to setup IP device’s date and time settings.
STEP 1: Click the [Date & Time] on the “Main Setup page”.
The “Date setting page” is displayed as below
STEP 2: Configure these settings with reference to the table below. If you
are still unsure what to set, contact your system administrator.
Date Setting
Parameters Description
SNTP/NTP
server
Click this to enable IP device’s SNTP/NTP function. This enables
this IP device to synchronize its time settings with a SNTP/NTP
server. You can use this function to make sure all your IP devices’
time
is the same. Additionally, with our embedded
digital-time-code in the streaming, you can tell the event sequence
accurately.
IP address: Enter the IP address of the SNTP/NTP server.
Sync time: Select the time interval for this IP device to
synchronize its time.
Set Click this to manually setup the date & time.