Speco Technologies SIPMPBVFH - Manual (Page 40)

2-36
Day/Night (CMOS Non-D/N Models)
This tab concerns the day and night switch timing for your camera. Please refer to the
table below.
Parameters Description
Switch from Day
mode to Night
mode
This value controls the level of light where camera
switches into night mode. Increasing it will make
camera switch to night mode at a darker illumination
level.
Switch if lasts
more than X
seconds
The camera will only switch day/night status if the
illumination level stays either above or below the
boundary for this much time. This is to prevent a
temporary brightness change from triggering unnecessary
day/night changes.
Brightness Meter This bar shows the illumination level at which cameras go