Sanyo VPC-E1090 - Manual (Page 29)

Camera Setup 17
Charging the Battery
English
Charging the Battery
1. Insert the battery into the camera and connect the DC
power supply cable with the power adapter as shown in
the picture.
2. Connect the power adapter to a live household outlet to
start charging. The power LED will blink during the
charging process.
3. Disconnect the DC power supply cable when the charging is
done. When the charging is done, Power LED turns off.
Charging the Battery with USB power
1. Turn the power off and connect the USB cable with the camera and the computer.
2. The power LED will blink during the charging process.
3. The power LED will turn off automatically when the charging is done.
4. Disconnect the USB cable.
Note:
1. The room temperature suitable for charging the camera is 6°C ~ 36°C. Power LED blinks
during the charge and turns off automatically after the charge.
2. The battery does not charge when room temperature exceeds 36°C or falls below 6°C.
Power LED will blink faster. The battery does not charge again automatically even when the
temperature comes back to 6°C ~ 36°C, once the charge stops by higher or lower
temperature.
3. To recharge the battery, plug out the DC power supply cable or USB cable and plug in again
by increasing or decreasing the temperature of the battery and the camera when room
temperature is not suitable for charging.