Static ip setup – Samsung SNC-B2331-FRA-QG User Manual
Page 8
8
Power Supply
Use the screwdriver to connect each line of the power cable to the corresponding port of the
camera.
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
STATIC IP SETUP
Manual Network Setup
Run
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
Select a camera in the search list.
Find the MAC (Ethernet) address labeled on
the rear of the camera.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
Click [Manual Set].
The MANUAL SET dialog appears.
The default values of
The default
In the pane, provide the necessary information.
MAC (Ethernet) Address : The MAC (Ethernet) address of the applicable camera will be
set automatically so you don't need to input it manually.
J
M
1.
2.
3.
SNC-B2331-ENG-QG.indd 8
2009-08-20 오전 11:42:37