Sharp MD-MT20H User Manual

Page 14

RECORDING USING THE OPTICAL DIGITAL CABLE

This is the method used for recording digi-
tal signals from CDs or MDs exactly as they
are stored on the original. Compared to re-
cordings made from analogue inputs, digi-
tal recordings have extremely high-quality
sound.

Connect the external equipment.
(See page 9.)

Start recording.

Synchro recording: Page 11

Before starting a synchro recording,
perform the following steps on the
equipment connected to this unit.

(1) First, put it in the playback mode.
(2) Next, put it in the pause mode.
(3) Finally, position it at the beginning

of the track you want to record.

(1) Insert a recordable MiniDisc, and

then press the REC button.

(2) Press the ENTER/SYNC button.
(3) Start the playback on the equipment

connected to this unit.

Manual recording: Page 12
(1) Insert a recordable MiniDisc, and

then press the REC button.

(2) Press the

button.

●

When recording from digital inputs, i t
is not necessary to adjust the record-
ing level.

Notes:

●

This unit incorporates a sampling rate
converter.
When this unit is connected to digital
equipment such as Digital radios or DAT
tape recorders that use a different sam-
pling frequency (32 kHz or 48 kHz), re-
cordings can still be made. (The sam-
pling frequency of this unit is 44.1 kHz.)

●

When making a digital recording from a
portable CD player (if the player has a
sound skip prevention function and this
function is turned on) the optical output
will drop out and digital recording will not
be possible. Be sure to turn the sound
skip prevention function off.

There are cases where digital recording
may be impossible.
In the following cases digital recording is
impossible, even if you are using digital
cables.

Playback

Digital cable

CD player, MD
player, etc.

Digitally recorded MiniDisc

Analogue recording is
possible.

Recording

Playback

Digital cable

Recording

When you attempt to make a new digital
recording from a track that was digitally re-
corded on a MiniDisc.

●

MiniDiscs are designed so that only first
generation digital copies can be made.
Further digital copies are prevented by
the SCMS (Serial Copy Management
System).

* MD-MT20H FOR UK(01-21)

99.3.11, 2:29 PM