3. operating conditions, 4. power supply, 4-1. voltage and power requirements – Sony MSW-A2000P User Manual

Page 8: 4-2. power cord

1-2

MSW-A2000

MSW-A2000P

n
AC power supply is required a capacity which is commen-

surate with rush current.
If the capacity of the AC power supply is not enough, the

breaker of AC power of a supply side may operate or this
unit may not operate normally.

1-4-2. Power Cord

w
Use the specified power cord only when connecting the

AC power.
Never use a damaged power cord.

For customers in the U.S.A. and Canada:

1 Power cord (approx. 2.4 m) ! 1-557-377-11
2 Plug holder (Brown)

3-613-640-01

Please contact your local Sony Sales Office/Service
Center.

For customers in the United Kingdom:

1 Power cord DK-2401(UK) (approx. 2.4 m)
2 Plug holder (Brown)

3-613-640-01

Plug holder is included in DK-2401(UK).

For customers in Europe except the United Kingdom:

1 Power cord DK-2401(AE) (approx. 2.4 m)
2 Plug holder (Brown)

3-613-640-01

Plug holder is included in DK-2401(AE).

If the unit is used in the area except above, please contact

your local Sony Sales Office/Service Center.

1-3. Operating Conditions
1-4. Power Supply

1-3. Operating Conditions

c
Good air circulation is essential to prevent internal heat

build-up. Place the unit in location with sufficient air
circulation.
Do not block the ventilation holes of the cabinet and the

front and rear panels.

Operating temperature: 5

dC to 40 dC

Operating humidity:

25 % to 80 %

(Condensation not allowed)

Storage temperature:

_20 dC to 60 dC

Locations to avoid:

. Areas where the unit will be exposed to direct sunlight

of any other strong lights.

. Areas near heat sources.
. Dusty areas or areas subject to vibration.
. Areas with strong magnetic field.
. Areas with much electrical noise.
. Areas with much static electricity.
. Areas that is impossible to find a specified room for

installation.
(Refer to “1-5. Installation Space” page 1-3.)

. Areas windtight.

Tilt allowance:

Within 30

Do not slant the front and rear of the
unit more than 30

c
Fix the unit securely to avoid drop when the unit is operat-
ed at not-horizontal place.

1-4. Power Supply

1-4-1. Voltage and Power Requirements

w
Be sure to operate the unit within the range of following

power voltage.

Power voltage:

AC 100 to 240 V

10 %

Power frequency:

50 Hz or 60 Hz

Power consumption: 2A (200 W)

(Without the optional kit.)

Rush current:

Power voltage 100 V IN; 10 A

Power voltage 240 V IN; 20 A

This unit’s power line has a switching regulator.

AC inlet