Sony MSW-A2000P - Manual (Page 16)

1-10 MSW-A2000
MSW-A2000P
1-8. Signal Inputs and Outputs
1-8. Signal Inputs and Outputs
Input connectors
1 AUDIO INPUT XLR 3-pin x 4 (1 set : CH1, CH2, CH3, and CH4)
Analog audio 4 channels
LOW OFF : _ 60 dBu, high impedance, balanced
HIGH OFF : + 4 dBu (Standard), high impedance, balanced
HIGH ON : + 4 dBm (Standard), 600 Z termination, balanced
1 TIME CODE IN XLR 3-pin x 1
Time code 0.5 to 18 V p-p, 10 k Z , balanced
2 VIDEO INPUT, REF.VIDEO BNC x 2 in loop through connection
Outside reference video signal (Black burst or composite sync)
0.3 V p-p, 75 Z , sync negative
2 VIDEO INPUT, COMPOSITE BNC x 2 in loop through connection
Analog composite video 1.0 V p-p, 75 Z , sync negative
2 VIDEO INPUT, COMPONENT BNC x 3 (1 set : Y, R-Y, and B-Y)
Analog component video
Y : 1.0 V p-p, 75 Z , sync negative
R-Y/B-Y : 0.7 V p-p, 75 Z
3 AUDIO INPUT (AES/EBU) BNC x 4 (1 set : CH1/2, CH3/4, CH5/6, and CH7/8)
Digital audio 8 channels
AES/EBU format, 2 channel mode, 1.0 V p-p, 75 Z
5 SDI INPUT BNC x 1 (active through out x 1)
Serial digital interface (270 Mbit/s) in conformity to SMPTE 259M & ITU-R BT.656
5 SDTI INPUT BNC x 1
Serial data transport interface (270 Mbit/s) in conformity to SMPTE 305M (SDTI) and
SMPTE 322M (SDTI-CP)
Remote connectors
4 REMOTE 2 PARALLEL I/O (50P) D-SUB 50P connector (Refer to Optional “Interface manual” for details.)
4 REMOTE1-IN (9P) D-SUB 9P connector (RS-422A interface)
Remote control
4 REMOTE1-OUT (9P) D-SUB 9P connector (RS-422A interface)
Remote control
4 RS-232C D-SUB 9P connector (RS-232C interface)
for ISR (Interactive Status Reporting)
4 CONTROL PANEL 10P connector
for an outside control panel connection only
4 VIDEO CONTROL D-SUB 15P connector
for a TBC remote controller (BVR-50) connection
4 (OPTION) D-SUB 9P connector
for an optional kit
Reduced drawing of rear panel
1 2
5
3
4