Standard Horizon CPV550 - Manual (Page 96)

Page 96 CPV550
18.14 VOICE SCRAMBLER
If privacy of communications is desired, a CVS2500 voice scrambler (VS) can be installed
in the transceiver. Contact your Dealer to have a CVS2500 installed.
18.14.0 Setting Up the Voice Scrambler
1. Select the chart page and press the [MENU] key two times. Move the ShuttlePoint knob
to highlight RADIO SETUP and press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight VHF SETTING and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight COMMON CHANNEL SETUP and press [ENT]
or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to select the channel group (USA, INTL, or CAN) you wish
to setup the Voice Scrambler and press [ENT] or move the ShuttlePoint knob to the
right.
5. Move the ShuttlePoint knob to highlight CH NO. and press [ENT] or move the
ShuttlePoint knob to the right.
6. Move the ShuttlePoint knob to select the operating channel you wish to setup the Voice
Scrambler and press [ENT].
7. Move the ShuttlePoint knob to highlight SCRAMBLER and press [ENT] or move the
ShuttlePoint knob to the right.
8. Another popup window will be shown with On and Off, move the ShuttlePoint knob to
select On and press [ENT] or move the ShuttlePoint knob to the right.
9. Move the ShuttlePoint knob to highlight SCRAMBLER CODE and press [ENT] or move
the ShuttlePoint knob to the right.
10. Move the ShuttlePoint knob to select the desired Scramble Code. The Scramble Code
can be select to 0, 1, 2, or 3.
11. To setup the Voice Scramble to another operating channel, repeat steps 5 through 10.
12. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
Figure 18.14.0 - CH EDIT menu