Scag Power Equipment MAG - Manual (Page 3)

1
GENERAL INFORMATION
1.1 INTRODUCTION
Your mower was built to highest standards in the industry.
However, the prolonged life and maximum efficiency of
your mower depend on you following the operating,
maintenance and adjustment instructions in this manual.
If additional information or service is needed, contact your
Scag Power Equipment Dealer.
We encourage you to contact your dealer for repairs. All
Scag dealers are informed of the latest methods to service
this equipment and provide prompt and efficient service in
the field or at their service shop. They carry a full line of
Scag service parts.
USE OF OTHER THAN ORIGINAL SCAG
REPLACEMENT PARTS WILL VOID THE
WARRANTY.
When ordering parts, always give the model and serial
number of your tractor and cutting deck. The serial plates
are located where shown in Figure 1-1.
Section 1
For pictorial clarity, some illustrations and Figures in this
manual may show shields, guards or plates open or removed.
Under no circumstances should your mower be operated
without these devices in place.
All information is based upon product information available
at time of approval for printing. Scag Power Equipment
reserves the right to make changes at any time
without notice and without incurring any obligation.
1.2 DIRECTION REFERENCE
The “Right” and “Left”, “Front” and “Rear” of the machine
are referenced from the operator’s right and left when seated
in the normal operating position and facing the
forward travel direction.
1.3 SERVICING THE ENGINE AND DRIVE
TRAIN COMPONENTS
The detail servicing and repair of the engine, hydraulic pump
and motors and gear boxes are not covered in this manual;
only routine maintenance and general service instructions
are provided. For service of these components during the
limited warranty period, it is important to contact your Scag
dealer or find a local authorized servicing agent of the
component manufacturer. Any unauthorized work done on
these components during the warranty period may void your
warranty.
Figure 1-1 Serial Plate Locations
Tractor Serial Number
Plate Location
Cutter Deck
Serial Number
Plate Location