Sony MZ-R910 - Manual (Page 117)

117
Operating Instructions
MZ-R910.3-234-699-01(1)
B Additional information
Messages
If the recorder cannot carry out an
operation, error messages may flash in the
display window as follows.
BANK FULL :
The phrase bank is almost full and
cannot store the phrase you tried to
enter. Delete some phrases from the
phrase bank, and then reenter the new
phrase.
BLANKDISC :
You tried to play an MD with no
recording on it.
BUSY :
You tried to operate the recorder while
it was accessing the recorded data.
Wait until the message goes out (in
rare cases, it may take a few minutes).
Data Save :
The MD recorder is recording
information (sounds) from the
memory to the disc. Wait until this
process is completed. Do not expose
the recorder to any physical shock, nor
disrupt power supply.
DISC FULL :
There is no more space to record on
the MD.
EMPTY :
You tried to erase data in the phrase
bank but no data have been recorded.
Hi DC in :
The power supply is higher than
required. Use the recommended
power sources.
HOLD :
You tried to operate the recorder with
the HOLD switch slid in the direction
of the arrow. Slide back the switch.
LINE OUT :
You pressed VOL +/– while the
“AUDIO OUT” parameter is set to
“LINE OUT.” Use the jog dial to set
the “AUDIO OUT” parameter to
“HeadPhone.”
LOW BATT :
The rechargeable battery or dry
battery is weak. Charge the
rechargeable battery or replace the dry
battery.
MEM OVER :
You started recording with the
recorder receiving continuous
vibration. Put the recorder on the
stable place and start recording again.
When playing (JEITA)
(Unit: approx. hours)
Batteries Stereo LP2 LP4
NH-14WM(A)
nickel metal
hydride
rechargeable
battery 30 38 42
LR6 alkaline
dry battery 44 52 62
NH-14WM(A)
nickel metal
hydride
rechargeable
battery + one
LR6 79 95 110
When to replace the batteries
When the dry battery or rechargeable
battery are weak, flashing r or “LOW
BATT” appears in the display. Replace the
dry battery or charge the rechargeable
battery.
The battery level indicator is approximate.
It may be more or less than the indication
depending on the operating condition.
Note
Stop the recorder before replacing battery.
02.4.30, 11:34 AM 117