Sennheiser EW 300 G2 User Manual

Page 59

To mount two EM 300 G2 into a rack:

Place the two receivers side by side onto a flat
surface, their bottom sides facing upwards.

Align the connecting plate

over the holes in the

bottom sides of the receivers.

Secure the connecting plate

to the receivers

using eight of the supplied recessed head screws
(M 3x6).

Hook the two rack mount “ears”

to the front

panels of the receivers.

Secure the rack mount “ears” to the receivers using
two of the supplied recessed head screws (M 3x6)
respectively.

Slide the receivers into a 19” rack.

Screw the rack mount “ears” tight.

When mounting only one receiver into a rack, use the
connecting bar

instead of the second receiver.

Hook the two rack mount “ears”

to the front

panel of the receiver.

Secure the rack mount “ears” to the receiver using
two of the supplied recessed head screws (M 3x6)
respectively.

Secure the connecting bar

to one of the rack

mount “ears”

using two of the supplied recessed

head screws (M 6x10).

If you are not front mounting the antennas, insert
the two covering plugs

into the antenna holes of

the connecting bar.

Slide the receiver into a 19” rack and screw the rack
mount “ears” tight.

To mount the receiver’s antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:

Screw the two BNC sockets

of the BNC extension

cables to the connecting bar

using the supplied

plain washers and nuts.

Connect the two BNC connectors

to the BNC

sockets

and

at the rear of the receiver.

Slide the receiver into a 19” rack.

Screw the rack mount “ears” tight.

Connect the two telescopic antennas

to the two

BNC sockets

Pull the telescopic antennas out and align them
upwards in a V-shape.