Smeg A3 - Manual (Page 5)

Instructions for the installer
43
The connection terminals are
located
at the rear of the
appliance. For electrical
connections see following
diagram. To access, remove
the rear cover.
For operation on 400-415V3N
∼∼∼∼
: use
an H05RR-F-type five-core cable (5 x
1.5 mm
2
).
For operation on 400-415V2N
∼∼∼∼
: use
an H05RR-F-type four-core cable (4 x
2.5 mm
2 ).
For operation on 230-240V
∼∼∼∼
: use an
H05RR-F-type three-core cable (3 x 4
mm
2 ).
The cable end to be connected to the
appliance must be provided with an
ground wire (yellow-green) at least 20
mm longer.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.