Samsung SV-661B - Manual (Page 26)

Menu
Press the menu button to open the on-screen menus. Press menu again to
close the menus. When you close the menus, the projector saves any changes
that you made. For more information about the on-screen menus, see page 16.
Mouse buttons
Use the mouse buttons to adjust settings in the menus. See “Using the
on-screen menus”.
Source (keypad only) or computer and video (remote control only)
When you have more than one source (computer and video) connected to the
projector, select between them by pressing the source button on the keypad or
the computer or video button on the remote control.
Standby
When you press the standby button, the display and audio turn off and a
blank screen is displayed for 15 minutes. You can change the amount of time
the projector stays in standby mode; see “Standby time” on page 23 for
details. The LED lights orange while the projector is in standby.
v If you press the standby button again within 15 minutes, the projector
returns to operation immediately. The LED changes from orange to green.
v If you press standby again after 15 minutes, there is approximately a
60-second delay before the lamp turns back on. The LED flashes green
while the lamp is re-lighting.
v If you do not press the standby button again, the lamp turns off after 15
minutes. The LED lights orange while the projector is in standby.
Volume (keypad only)
To increase the volume, press the volume + button. To decrease the volume,
press the volume - button.
Volume adjustments are saved for each source that you have connected.
Using the on-screen menus
The projector has six drop-down menus that you can use to make image
adjustments and change a variety of settings. Most of these adjustments are
not available directly from the keypad.
Note: Some menu items might be unavailable (grayed out) at certain times.
This indicates that the item is not applicable to your setup (for
example, video standards do not apply to computer sources) or the
item is not enabled until another selection is made (for example,
Manual Tracking is not available until Auto Image is turned off).
To open the on-screen menus, press the menu button on the keypad or remote
control. This changes the volume, source, and standby buttons on the keypad
16 iL2120 IBM Value Data/Video Projector, iL2220 Conference Room Data/Video Projector: User’s Guide