Circuit adjustments, 1. tv input sub contrast adjustment (vpnt-scon), 4. p & p sub contrast adjustment (sc-sydr) – Sony KP 48S75 User Manual
Page 49
– 49 –
KP-43T75/48S75/
53N77/53S75/61S75
RM-Y906
5-1. TV INPUT SUB CONTRAST ADJUSTMENT
(VPNT-SCON)
1. Receive the color-bar signal.
2. Mode
: Personal 1 or 2.
PICTURE
: maximum
COLOR
: maximum
BRIGHTNESS
: center
TRINITONE
: medium
SERVICE DATA VPNT SCON
: 7
3. Set to service mode.
4. Connect an oscilloscope between pin
7 of CN204 (A board)
and ground.
5. Select “ VPNT-SCON ”, and adjust so that the wave from
level is 1.80
±
0.05Vp-p.
6. Write the data into memory.
MUTING n ENTER
White
1.80
±
0.05Vp-p
Black
Fig. 5-1
SECTION 5
CIRCUIT ADJUSTMENTS
5-2. VIDEO INPUT SUB-HUE AND SUB-COLOR
ADJUSTMENT (VPNT-SHUE, SCOL)
1. Select VIDEO1 input and supply the color-bar signal.
2. Mode
: Personal 1 or 2.
PICTURE
: maximum
COLOR
: center
BRIGHTNESS
: center
TRINITONE
: medium
SERVICE DATA VPNT-SHUE
: 7
SERVICE DATA
VPNT-SCOL
: 7
3. Set to service mode.
4. Connect an oscilloscope between pin
5 of CN204 (A board)
connecter and ground.
5. Select “ VPNT-SHUE, SCOL ”, and adjust them to have VB1
= VB4 and VB2 = VB3 in the waveform levels.
6. Increase SCOL by 2 steps.
7. Write the data into memory.
MUTING n ENTER
VB1 VB2 VB3 VB4
Fig. 5-2
5-3. COMPONENT INPUT SUB-HUE AND SUB-COLOR
ADJUSTMENT (DAC-UVSH, UVSC)
1. Select VIDEO 4 and supply the color-bar signal.
VIDEO input
2. Mode
: Personal 1 or 2.
PICTURE
: maximum
COLOR
: center
BRIGHTNESS
: center
TRINITONE
: medium
SERVICE DATA DAC UVSH
: 31
SERVICE DATA
DAC UVSC
: 31
3. Set to service mode.
4. Connect an oscilloscope between pin
5 of CN204 (A board)
connecter and ground.
5. Select “ DAC-UVSH, UVSC ”, and adjust them to have VB1
= VB4 and VB2 = VB3 in the waveform levels.
6. Write the data into memory.
MUTING n ENTER
VB1 VB2 VB3 VB4
Fig. 5-3
5-4. P & P SUB CONTRAST ADJUSTMENT
(SC-SYDR)
1. Receive the signal.
TV terminal (sub)
: color-bar signal
VIDEO terminal (main) : no signal
2. Set to service mode and set to P & P mode.
3. Connect an oscilloscope between pin
7 of CN204 (A board)
and ground.
4. Select “ SC-SYDR ”, and adjust so that the wave from level
is 1.65
±
0.05Vp-p.
5. Write the data into memory.
MUTING n ENTER
White
1.65
±
0.05Vp-p
Black
Fig. 5-4