Service, Wheel replacement, Brush replacement – Woodstock W1764 User Manual
Page 21: General
-19-
W1764 Power Feeder
SE
RV
IC
E
Wheel Replacement
If you damage one or more wheels, you can easily replace
the wheels.
To replace a wheel, do these steps:
1. DISCONNECT THE FEEDER FROM POWER!
2. Using a #2 Phillips screw driver, remove the three
cover screws and the cover (
Figure 18).
3. Put on your safety glasses and remove the retaining
ring (
Figure 18) using external retaining ring pliers.
4. Replace the wheel and reassemble the power feed-
er.
Brush Replacement
Figure 19. Brush set replacement.
Figure 18. Wheel replacement.
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
General
MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
After a long period of time you may notice the motor lose
some power or begin to growl during operation. This indi-
cates that the motor brushes are worn and need replace-
ment. The brushes can be easily replaced.
To replace the brush set, do these steps:
1. DISCONNECT THE FEEDER FROM POWER!
2. Using a standard #2 screw driver, unscrew both
brush caps (
Figure 19).
3. Replace the brush set (Figure 19) and reinstall the
caps.