Setup, Inventory, Unpacking – Woodstock W1764 User Manual

Page 12

-10-

W1764 Power Feeder

The following is a description of the main components

shipped with the Model W1764. Lay the components out

to inventory them.

Note: If you can't find an item on this list, check the

mounting location on the machine or examine the pack-

aging materials carefully. Occasionally we pre-install cer-

tain components for safer shipping.

Box Inventory (Figures 3 & 4)

Qty

A. Base ..........................................................1

B. Arm Bracket ................................................1

C. Power Feeder Unit ........................................1

D. Arm ..........................................................1

E. Base Mounting Template .................................1

F. Elbow Clamp Assembly ...................................1

G. Ball Joint Assembly ........................................1

H. Hardware Bag (Figure 4) .................................1

—Cap Screw M10-1.5 x 25mm (Elbow Clamp) .........1

—Hex Bolt M10-1.5 x 50mm (Elbow Clamp) ...........3

—Lock Lever (Arm Bracket Clamp) .....................1

—Hex Nut M8-1.25mm (Arm Bracket Clamp) ..........1

—Flat Washer 8mm (Arm Bracket Clamp) ............1

—T-Handle and Pivot Bar (Ball Joint Assembly) .......1

—Hex Bolt M10-1.5 x 35mm (Base) .....................4

—Lock Washer 10mm (Base) .............................8

—Hex Nut M10-1.5mm (Base) ............................7

Inventory

Keep machine disconnected from

power until instructed otherwise.

This machine has been carefully packaged for safe trans-

portation. If you notice the machine has been damaged

during shipping, please contact your authorized Shop Fox

dealer immediately.

Unpacking

SETUP

Figure 3. Box inventory.

Figure 4. Hardware inventory.