Woodstock W1764 - Manual (Page 14)

-12-
W1764 Power Feeder
SE
TU
P
Figure 5. Assembled elbow clamp
assembly.
To assemble the power feeder, do these steps:
1. Oil the T-handle threads and position the elbow
clamp assembly onto the feeder base as shown in
Figure 5.
2. Thread the T-handle into the feeder base until the
elbow is snug.
3. Insert the arm into the ball-joint ball and secure
both together with the M10-1.5 x 25mm cap screw
shown in Figure 6.
4. Insert the ball joint assembly into the power feed
socket shown in Figure 6.
5. Insert the ball-joint socket into the power feed sock-
et as shown in Figure 7, so it rests against the ball-
joint ball.
Note: Lubrication is not necessary for the ball joint
assembly.
6. Align the ball-joint socket with the power feeder
socket and insert the pivot bar as shown in Figure 7.
7. Lightly oil the T-handle threads.
8. Thread the T-handle through the pivot bar so the
end of the T-handle bolt presses against the ball-
joint socket firmly as shown in Figure 7.
Elbow
Clamp
Figure 7. Assembled ball joint assembly.
Figure 6. Arm, ball joint and socket
assembly.
Power Feed
Socket
Arm
Ball-Joint Ball
Ball-Joint Socket
T-Handle
Pivot Bar
T-Handle
Feeder
Base
Cap Screw
Continued on next page
To correctly position this power feeder on your table top,
completely assemble the power feeder first, then refer to
Base Mounting on Page 15. The reason for this order, is
that with the power feeder unit completely assembled, it
will be easier to locate where on the table top you will
need to drill your base mounting holes, so you can take
advantage of the full range of power feeder swing and
adjustments.
Assembly