Woodstock W1764 - Manual (Page 15)

-13-
W1764 Power Feeder
SE
TU
P
Figure 8. Arm bracket gearing.
Arm
9. Place the arm into the arm bracket so the teeth of
the gear and arm mesh as shown in Figure 8.
Note: No lubrication is required for the gear or rack
teeth. Oil or grease will gather debris making the
horizontal adjustment of the power feeder difficult.
10. Secure the arm bracket cover onto the arm bracket
with three M10-1.5 x 35 hex bolts and washers
( Figure 9).
Note: Make sure that you do not tighten the hex
bolts so much as to prevent the arm from sliding
in and out of the arm bracket when the horizontal
crank is turned.
11. Insert the horizontal crank completely so it engages
the spline ( Figure 8) in the gear.
12. Insert the lock lever, flat washer, and hex nut as
shown in Figure 9.
13. Place the E-clip on the end of the horizontal crank
to retain the crank as shown in Figure 10.
14. Turn the horizontal crank to make sure that the
cover bolts are not too tight or too lose. Adjust the
three hex bolts as required to achieve a slight drag
between the arm and arm bracket.
Arm Bracket
Figure 10. Horizontal movement handle
E-clip.
E-Clip
Continued on next page
Figure 9. Assembling arm bracket.
Horizontal Crank
Arm Bracket
Cover
Lock Lever
Spline
Flat Washer
Hex Nut