Sony HDW-M2000 User Manual
Page 119

Chapter 9
Setup Menus
Chapter 9 Setup Menus
9-23
Menu items in the range 700 to 799, relating to video control (Continued)
Item name
Settings
Item number
726
H BLANKING WIDTH
Select the horizontal blanking width of the video output signal.
NAROW : Digital blanking (narrow)
WIDE: Analog blanking (wide)
When WIDE is selected, the horizontal blanking width complies with RS170A, and
normally the blanking is widened and the image becomes narrower. It is
recommended to select NAROW at the editing stage, then later, for broadcast
transmission to select WIDE, to output a signal conforming to the standard.
727
VIDEO EDIT PREVIEW
SWITCHER
Set the output phase for the video playback signal when any of the ASSEMBLE,
VIDEO, AUDIO CH1 to CH4, CUE and TC buttons is lit.
INT : The video playback signal output phase is the same as the output phase in
E-E mode. Use this setting when editing with a single VTR, or when
previewing while watching the VTR output signal.
EXT: The video playback signal output phase is the same as the phase of an
input video signal or external reference signal.
Note
Whichever setting is used, the correct editing results will be obtained. When,
however, you are using an external switcher to switch the video output signal
from this unit for the purposes of preview, select EXT. This will prevent any
image shifts at editing IN and OUT points.
728
OUTPUT SCH PHASE
Set the subcarrier H phase.
0 to 800H to FFFH
740
MASTER LEVEL (HD)
Adjust the high-definition video signal output from the HDSDI OUITPUT
connector.
This adjusts the Y, PB, and PR levels simultaneously.
0.0%(0H) to 100%(800H) to 141.3% (B4EH)
741
Y LEVEL (HD)
Adjust the Y level of the high-definition video signal output from the HDSDI
OUITPUT connector.
0.0% (0H) to 100% (800H) to 141.3% (B4EH)
732
COMPOSITE MODE
Select the chroma filter through which the composite video output signals pass.
WIDE : Output via SMPTE wide
STD: Output via SMPTE standard (narrow)
742
P
B
LEVEL (HD)
Adjust the P
B
level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0.0% (0H) to 100% (800H) to 141.3% (B4EH)
Control the H sync phase of the high-definition video signal output from the
HDSDI OUTPUT connector according to the menu.
0 to 80H to FFH
Fine control the H sync phase of the high-definition video signal output from the
HDSDI OUTPUT connector according to the menu.
0 to 3FFH
743
P
R
LEVEL (HD)
Adjust the P
R
level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0.0% (0H) to 100% (800H) to 141.3% (B4EH)
745
SETUP LEVEL (HD)
Adjust the setup level (59.94 Hz mode)/black level (50 Hz mode) of the high-
definition video signal output from the HDSDI OUTPUT connector.
0 to 110H to 220H
746
SYNC PHASE (HD)
747
FINE (HD)