4 items in the extended setup menu – Sony HDW-M2000 User Manual
Page 118

Chapter 9
Setup Menus
9-22
Chapter 9 Setup Menus
9-4 Items in the Extended Setup Menu
Menu items in the range 700 to 799, relating to video control (Continued)
Menu items in the range 700 to 799, relating to video control (Continued)
(Items 715 to 720: Settings for controlling the SD video processing system according to the menu settings.)
Item number Item name
Settings
712
VIDEO PROCESS ON
CAP LOCK 2FIELD
When the function menu item CAPSTN or setup menu item 106 is set to 2F for 2-
field playback, select whether or not to carry out a “picture shift”.
OFF : No picture shift
ON: Carry out picture shift.
Note
To eliminate the adverse effect of the residual chrominance subcarrier component
in the Y signal that is the result of the Y/C separation, this unit automatically
applies a shift to the playback image in the H direction, so that even in 2-field
playback a satisfactory image can be obtained.
713
VIDEO SETUP
REFERENCE LEVEL
(When operating in 59.94
Hz mode)
Set the video setup amount to be added to the composite output signal.
Note
The setup amount specified in this menu item has no connection with the setting
of F5 (SETUP/BLACK) in function menu page 2.
Sub-Item
OUTPUT LEVEL
0.0% to 7.5% to 10.0%: Set the setup amount to be added to the output signal
in this range, in 0.5% increments.
Item number
Item name
715
VIDEO GAIN CONTROL
716
CHROMA GAIN
CONTROL
717
CHROMA PHASE
CONTROL
718
SETUP LEVEL (59.94/60
Hz mode)/BLACK LEVEL
(50 Hz mode)
719
SYSTEM PHASE SYNC
Adjust the SD output signal sync phase.
0 to 80H to FFH
720
SYSTEM PHASE SC
Adjust the SD output signal subcarrier phase.
0 to 3FFH
Notes
• When you make settings for menu items 715 to 721,
set the function menu item V.PROC to MENU.
When it is set to MENU, all controls for video output
processing on the control panel are disabled.
• Changing the settings of menu items 719 and 720
changes the phase of HD output signals as well as
that of SD.
After changing the settings, use the F1 (SYNC) and
F2 (SC) items on function menu page 3 to readjust
the phase of HD output signals.
Settings
Adjust the video output level.
0 to 800H to B50H
Note
This item is valid for both HD and SD outputs.
Adjust the chroma output level.
0 to 800H to B50H
Note
This item is valid for both HD and SD outputs.
Adjust the SD chroma phase.
0 to 80H to FFH
Note
This item is valid for both HD and SD outputs.
Adjust the SD setup level (black level).
0 to 110H to 220H
721
Y/C DELAY
For playback from an analog Betacam cassette, adjust the Y/C delay.
0 to 800H to FFFH
(Continued)