beautypg.com

Routine maintenance, Cleaning of cabinet, Replacement of fluorescent lamp – Sanyo BLOOD BANK MBR-304DR User Manual

Page 21: Warning

background image

20

ROUTINE MAINTENANCE

WARNING

Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in

order to prevent electric shock or injury.

Ensure you do not inhale or consume medication or aerosols from around the unit at the time of

maintenance. These may be harmful to your health.

Cleaning of cabinet

Clean the unit once a month. Regular cleaning keeps the unit looking new.

Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all accessories.

If some of them are dirty, use a cloth containing diluted neutral dishwashing detergent (Undiluted

detergent may break the plastic parts. For the dilution, follow the instruction enclosed with the

detergent). When a diluted neutral dishwashing detergent is used, wipe the cabinet or accessories

thoroughly with a cloth soaked in clean water. Then wipe the cabinet or accessories unit with a dry cloth

to eliminate the moisture.

Never pour water onto or into the unit. Doing so can damage the electrical insulation and may cause

electric shock or short circuit.

The compressor and other mechanical part are completely sealed. This unit requires absolutely no

lubrication.

Remove dust from the power supply plug periodically. A dusty plug or improper insertion may pose a

hazard.

Replacement of fluorescent lamp

The fluorescent lamp is placed horizontally in the upper front of the chamber. Follow the procedure

below to replace the lamp.

1. Turn off the fluorescent light switch and disconnect

the power supply plug.

2. Hold the cover of the light and pull downward with

lead wire to remove the lamp from stopper. (Fig. 1)

3. Remove the water-proof rubber on the left. (Fig.

2)

4. Remove the socket on the left. (Fig. 2)

5. Take out the fluorescent lamp gently from the

protective cover.

6. After placing a new fluorescent lamp in the

protective cover, replace the socket and then replace

the water-proof rubber.

7. Fix the light with the stoppers.

Fig. 1

Fig. 2

Water-proof rubber

Socket