Siemens MCM 1755 NTD - Manual (Page 24)

Color monitor MCM 1755 NTD
16 - English A26361-K472-Z100-2-5E19
Changing the monitor settings
With the buttons and controls on the control panel, you can change the monitor
settings.
Ê Open the cover of the control panel by pressing on the arrow and pulling the
cover slightly downward.
7 8 9 1 2 3 4 5 6
COLOR
TEMP.
1 = Picture position
2 = Picture size
3 = Edges
4 = Color temperature
5 = Factory settings 6 = Degauss
7 = Arrow buttons
8 = Brightness
9 = Contrast
The controls are labeled with symbols and are explained below.
i
Some buttons have two assignments. The second assignment is active
when you press these buttons twice.
Adjusting the brightness and contrast
You will increase the life of your screen if you adjust the contrast and brightness to
low or medium.
Adjusting the brightness
Increasing the brightness = turn control clockwise
Reducing the brightness = turn control anticlockwise
Adjusting the contrast
Increasing the contrast = turn control clockwise
Reducing the contrast = turn control anticlockwise