Sundance Spas Maxxus - Manual (Page 21)

Page 18
NOTE: Auto Shut-off -- Anytime a pump has been manually turned on,
it will automatically turn off after approximately 20 minutes. If at this
time you desire more jet operation, you may simply turn them back on.
You will notice that occasionally, when you touch the button to turn off the high
speed of the pump, the low speed continues to operate. This is normal if the hot
tub is in the “Standard” mode and calling for heat, if a filter cycle is in progress or
if the heater has recently turned off. (After the heater turns off, the pump contin-
ues to circulate water for approximately 30 seconds to cool the heating element.)
Initial Start Up
The hot tub control has automatic functions that operate upon start up. Upon
power up, the read out will display a three digit number that identifies the soft-
ware revision. This number will then change to “888” while the system is
booting up. Also during the boot up, all of the indicator LED’s will be lit.
At the end of the boot up, the water temperature will be displayed. If the tem-
perature is below 100˚F (38˚C), the low speed pump and the heater will turn
on until the temperature rises to the preset 100˚F (38˚C). Approximately
two minutes after the system has been initially powered up, the first
filtration cycle will begin to operate. Any time after the boot up, you will
be able to select a pre-programmed filter cycle and reset your temperature set
point.
Selecting Filter Cycles
FILTRATION
Proper filtration is an important key to maintaining the clarity of your hot tub’s
water. The Filtration system is designed for unsurpassed effectiveness at
removing debris and suspensions from the water anytime the water is circu-
lating.
You may change the filtration cycle start time by one of the following methods:
1. Turn power to the hot tub off and then back on at the breaker, or
2. Press and hold for three seconds the “WARMER” and “COOLER” but-
tons at the same time. When the currently set cycle appears (F1-F6) press
the jets 1 button one time and the control will go into the initial power up
routine.
Example: If you want your first filter cycle start time to be at 4 PM, perform
above functions just before the desired start time. Filter cycle start time may
vary slightly.
Your hot tub comes with six pre-programmed filtration cycles (F1-F6) and two
lockout modes (L1-L2). Of the six filter cycles, three cycles are in the standard
mode and three cycles are in the economy mode.