Sundance Spas Maxxus - Manual (Page 14)

Page 11
Electrical Installation Instructions
For Connection to 240V Service
(Note: The Bali model may be connected to 120V service. See the Instructions on next page.)
IMPORTANT NOTICE: The electrical wiring of this hot tub must meet the
requirements of the National Electrical Code (NEC) and any applicable state
or local codes. The electrical circuit must be installed by a qualified electri-
cian and approved by a local building/electrical inspection authority.
1. This hot tub must be permanently connected (hard-wired) to the power
supply. No plug-in connections or extension cords are to be used in
conjunction with the operation of this hot tub. Supplying power to
the hot tub which is not in accordance with these instructions will void
both the independent testing agency listing and the manufacturer’s war-
ranty.
2. The power supplied to this hot tub must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to Table
No. 1, Power Supply Options and Requirements, page 12.
– Wire size must be appropriate per NEC and/or local codes.
– We recommend type THHN wire.
– All wiring must be copper to ensure proper connections. Do not use
aluminum wire.
– When using wire larger than #6, add a junction box near the hot tub
and reduce to short lengths of #6 wire to connect to the hot tub.
4. The electrical supply for this product must include a suitably rated switch
or circuit breaker to open all ungrounded supply conductors to comply
with Section 422-20 of the National Electrical Code, ANSI/NFPA 70. The
disconnecting means must be readily accessible to the hot tub’s occu-
pant but installed at least 5 feet (1.5m) from hot tub water.
5. The electrical circuit supplied for the hot tub must include a suitable
ground fault circuit interruptor (GFCI) as required by NEC Article 680-42.
6. To gain access to the hot tub’s power terminal block, remove the wood
cabinet panel on the control panel side of all models except Aruba. For
Aruba models, remove the wood cabinet panel from the lounge side.
Then open the door to the control box. (Illustration No. 1, item 1).
7. Use the appropriate power supply inlet and remove the panel from the
front of the hot tub to allow you to feed the cable through to the control
box. Install the cable with connector through the large opening provided
in the bottom of the control box.
8. Connect wires, color to color, on terminal blocks TB1 and ground
(Illustration No. 1). TIGHTEN SECURELY! All wires must be hooked up or
damage could result.
9. Close the control box door and reinstall the cabinet side panels.