Sundance Spas Maxxus - Manual (Page 20)

Page 17
WARMER AND COOLER BUTTONS
The hot tub’s thermostat is to provide you with optimum control of the hot
tub water temperature. This temperature set point can be adjusted from 65˚F
(18˚C) to 104˚F (40˚C). In conjunction with setting the temperature, these
two buttons are used in changing the filter cycles (see “Selecting Filter
Cycles”, page 18).
LIGHT
The control panel button labeled LIGHT activates the underwater hot tub light
when depressed and the LED indicator light above this sensor comes on
when the hot tub light is turned on. The light has a one hour default.
There are two colored lenses included with your hot tub which may be placed
over the light lens inside the hot tub. To remove a lens, simply rotate it coun-
terclockwise and pull.
JETS OR JETS 1
The JETS OR JETS 1 button controls the 2-speed pump. Pressing this but-
ton switches the pump from off, to low speed, to high speed, and back to off.
JETS 2
The JETS 2 button controls the high speed pump 2 featured on Palermo and
Bahia models.
JETS 1
JETS 2
COOLER
LIGHT WARMER
Illustration No. 7
Palermo and Bahia
Digital Command Center
Light
indicator
Red LED display: can shown current water temperature,
set water temperature, error messages, and filter modes.
Controls
light
Controls
2-speed
pump 1 Pump 1
indicator
These buttons:
1. Display temperature setting.
2. Change temperature setting.
3. Perform other programming
functions.
Controls
high speed
pump 2
Pump 2
indicator
Indicates
heater is on.