Sharp MD-M2H - Manual (Page 7)

6
PREPARATION FOR USE
■ Aerial connection
■ Speaker connection
Connect each speaker wire to the SPEAKER ter-
minals as shown.
Use speakers with an impedance of 4 ohms or
more, as lower impedance speakers can damage
the unit.
Caution:
● Before connecting the speakers to the unit, con-
nect the speaker wires to the speakers first.
Then, connect the speaker wire to the terminals
on the unit.
● Connect the speakers to the main unit before you
use the system. If the speakers are not connected
before operation, the system may be damaged.
Notes:
● Connect the black wire to the minus (–) terminal,
and the red wire to the plus (+) terminal.
● Do not mix the right channel and left channel
wiring when connecting the speakers to the unit.
● Do not let bare speaker wires touch each other
as this may damage the amplifier and/or speak-
ers.
Right speaker Left speaker
Red
Red
Black
Black
LEFT
RIGHT
RATESD SPEAKER
IMPEDANCE :
4 OHMS MIN.
1 2 3
Red
Black
Supplied FM aerial
Connect the FM aerial wire to the FM 75 OHMS
socket and position the FM aerial wire in the direc-
tion where the strongest signal can be received.
Supplied AM loop aerial
Connect the AM loop aerial wire to the AM LOOP
socket.
Position the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, etc., or attach
it to a stand or a wall with screws (not supplied).
Notes:
● Do not place the aerial on the main unit as it may
result in noise pickup from the internal digital elec-
tronics.
Place the aerial away from the unit for better re-
ception.
● If the AM loop aerial and the FM aerial wire are
placed near the AC power lead, interference may
result.
External FM aerial
Use an external FM aerial if you require better re-
ception.
Consult your dealer.
1 2 3
FM aerial
AM loop aerial External FM aerial
AM LOOP
FM
75 OHMS
● Unplug the AC power lead from the AC socket
before connecting or disconnecting any com-
ponent.