Sharp MD-M2H - Manual (Page 13)

12
MINIDISC OPERATION
1
Press the ON/STAND-BY button to turn the
power on.
2
Press the MD button.
3
Load a MiniDisc in the direction indicated by the
arrow on the MiniDisc, with the labeled side fac-
ing up.
● The total number of tracks and the total playing
time on the MiniDisc will be displayed.
4
Press the
0 6
button.
● If the MD has a track name, the name will ap-
pear and scroll across the display. Then, the
elapsed playing time will appear.
● If the MD has no track names, the elapsed play-
ing time will appear.
● When the last track has been played back, the
unit will stop automatically.
To interrupt playback:
Press the
0 6
button.
● "
6
" will appear.
● Press the
0 6
button again to resume playback
from the same point.
To stop playback:
Press the ■ button.
To remove a MiniDisc:
Press the
7
MD EJECT button.
Notes:
● If TV or radio interference occurs when using the
MD, move the unit away from the TV or radio.
● Although MiniDiscs will not normally skip due to
vibration, you may hear a skip in the sound if
there is continuous vibration.
If the volume is turned up too high, a skip may
occur depending on the contents of the MD.
If this happens, turn the volume down and the
skipping should stop.
● If an error message is displayed during MD
operation, see "ERROR MESSAGES" on
page 47.
■ MD playback
2
1
4
7
4
H
1
2
H
3
DISC
MEMORY
RANDOM
TOTAL
REMAIN
REC kHz
MHz SLEEP
Disc name
Flash
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
REC kHz
MHz SLEEP
Total number of tracks
(Displayed only when a disc name has
been programmed)
Total playing time