Sharp MD-M2H - Manual (Page 43)

42
■ Connecting external units
Before connecting external units, set this unit to the stand-by mode and turn off the power to the external
units.
Connecting to stereos or MD/CD players (equipment which can output analogue signals)
The other MD/CD player
Commercially available lead
with 3.5 mm (1/8") stereo
mini-plug and RCA plugs
T o t h e o u t p u t /
headphone socket
RIGHT LEFT
To the analogue
output sockets
LEFT RIGHT
RIGHT LEFT
● Red plug → To RIGHT
● White plug → To LEFT
Commercially available RCA lead
AUX INPUT LEVEL
RIGHT LEFT
RIGHT LEFT
Note:
● When the audio output signal of an external unit is connected to this unit, oscillation may occur.
In such a case, disconnect either the input or output connection.
■ Headphones
Notes:
● Before plugging in or unplugging the headphones, make sure the volume level is reduced.
● Be sure your headphones have a 3.5mm (1/8") diameter plug and are between 16 ohms and 50
ohms impedance. The recommended impedance is 32 ohms.
● When headphones are connected, the speakers are disabled automatically.
Adjust the VOLUME control for the desired volume.
USING EXTERNAL UNITS