Shindaiwa T2510 - Manual (Page 5)

5
Product Description
Figure 4
Specifications
T510 dry weight
(less attachments) .......................................................11.0 lb./5.0 kg
T510X dry weight
(less attachments) .......................................................11.3 lb./5.1 kg
Engine model ....................................................................... SF510E
Engine type .................................... with Power Boost Chamber
Bore x stroke ............................................... 1.3 x 1.1 in./34 x7 mm
Displacement ........................................................ 1.5 cu. in./ 4.5 cc
Maximum power ........................................................1.1 HP/0.8 kW
@ 7500 rpm (min -1 )
Fuel/oil ratio ............................... 50:1 with ISO-L-EGD or JASO FC
class -cycle mixing oil*
Carburetor type .................................Walbro WYL, diaphragm-type
Fuel tank capacity ..................................................... 0.3 oz./600 ml
Ignition ............................................................. One-piece electronic,
program-controlled
Spark plug .....................................................................NGK CMR5H
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Specifications are subject to change without notice.
Air cleaner type ...................................... Non-reversible heavy-duty
filter element
Starting method ........................................................................Recoil
Stopping method .............................................................Slide switch
Transmission type ..............................Automatic, centrifugal clutch
w/bevel gear
EPA Emission
Compliance Period** .......................................................Category A
** The EPA emission compliance referred to on the emission compliance
label located on the engine, indicates the number of operating hours for
which the engine has been shown to meet Federal emission requirements.
Category C = 50 hours (Moderate), B = 15 hours (Intermediate) and A = 300
hours (Extended).
n Engine and shaft assembly
n Cutting attachment shield
n Cutting attachment
n Kit containing cutting attachment shield
mounting bracket and hardware, this
owner’s/operator’s manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a hex
wrench set, a spark plug/screwdriver
combination wrench, and a spanner.
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
* meets or exceeds these specifications and is
recommended for all Shindaiwa products.
T2510X TRIMMER
Outer Tube
Trimmer Head
Grip
Cutting
Attachment Shield
Gear case
Handle
Throttle
Trigger
Throttle
Interlock
Ignition
Switch
Fuel
Tank
Barrier
Bar
T2510 TRIMMER
Outer Tube
Trimmer
Head
Grip
Cutting
Attachment Shield
Gear case
Handle
Throttle
Trigger
Throttle
Interlock
Ignition
Switch
Fuel
Tank
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Hanger
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized
modifications or alterations to any of
these units or their components.