Reader mode setup (rf only), Reader mode setup, And button – Samsung SSA-S2000 User Manual
Page 18
18_
Reader Mode Setup
- You can specify the operation mode for the device.
- Once a mode is specifi ed, it will not switch until you perform the initialization.
- You must keep the Master Card in safe for later use as it is required for your change to the device settings.
- If progression is halted for more than one minute during any of the following processes, the operation mode of the reader
will return to the previous state.
READER MODE SETUP (RF ONLY)
No Master Card or Master PIN is ever registered.
If you remember the Master Card or the Master PIN was registered, initialize the product and try again.
When you turn on the product, all of the 3 LED indicators will fl ash with a
beep.
No flashing of the 3 indicators denotes that the reader mode is already
specified.
Press Button
0
and Button
1
in sequence and press
ENT
Present a card that you want to register as the Master Card to the device.
When the Master Card is registered, only the red LED indicator flashes.
Present cards to register with the device one after another, and the device
will register them with a beep. If you don’t want to register the cards right
now, simply jump to Step 5 above without through Step 4 above.
Present the registered Master Card to the product once again.
The device enters Standby mode with only the orange LED indicator flashing.
1.
•
2.
3.
4.
5.
6.
reader mode setup
X
Y
Z
[
\
]
^
_
`
lzj
lu{
W
i
zzhTzYWWW
X
Y
Z
[
\
]
^
_
`
lzj
lu{
W
i
zzhTzYWWW
О
О
О
tGj
X
Y
Z
[
\
]
^
_
`
lzj
lu{
W
i
zzhTzYWWW
tGj
X
Y
Z
[
\
]
^
_
`
lzj
lu{
W
i
zzhTzYWWW
X
Y
Z
[
\
]
^
_
`
lzj
lu{
W
i
zzhTzYWWW