SMC Networks Barricade SMCBR14UP - Manual (Page 38)

7.10 | Advanced Setup - ROUTING
The Routing Table lets you determine which physical interface address to use for outgoing IP data grams.
If you have more than one router and subnet, you will have to enable the routing table to allow packets to
find the routing path. This allows different subnets to communicate with each other. The settings in the
routing table are used to support static and dynamic routing functions. RIPv1 is a protocol where the IP
address is routed through the Internet. RIPv2 is an enhanced version of RIP v1 with added features such as
Authentication, Routing Domain, Next Hop Forwarding, and Subnet Mask Exchange.
Enable Static Routing by selecting the radio button next to Enable.
• Static Routing: Allows you to specify up to 8 routing rules. You can enter the destination IP
address, subnet mask, gateway, hop for each routing rule, and then enable or disable the rule by
toggling the Enable check box. Once the routing table settings are configured, click Save.
38