Siemens MCC-3298 - Manual (Page 31)

29
3 Operating the SAMMS-LV Device
Function
Number
Function Description Range Step Size Default Value
F18 Display the elapsed motor running time
in tens of hours.
0.0 - 6553 (x 10 hr.) 0.1x10hr.
up to 999.9,
1x10hr.
up to 6553
N/A
F19 Display the number of motor starts in
tens of hours.
0.0 - 6553 (x 10) 0.1x10
up to 999.9,
1x10
up to 6553
N/A
F20 Display the number of overload trips. 0 - 9999 1 N/A
F21 Reset motor data. Zeroes the elapsed
running time, the number of starts, and
the number of overload trips.
N/A N/A N/A
F22 Set process current warning 0-100% I 1% I OFF
F23 Jam protection ON/OFF N/A ON
F23A Select jam pickup current 120-400% I 5% 200%
F24 Loss of Load ON/OFF N/A ON
F24A Select loss of load pickup current 20-95% of running
current
5% 50%
F25 Display percentage of motor winding
temperature
0 to 250% 1% N/A
F26 Select baud rate 2400/4800/9600 N/A 4800
F27 Select address 1-224 1 200
FLC FLC
FLC
3.28 Using the SAMMS-LV Device Func-
tions
This section lists the 28 major motor control and protection
functions and several related functions (F0-F27, F4A, F5A,
F12A, F23A, and F24A) and how to use them. The functions
available for each version of the SAMMS-LV device are shown
in table 3.7. Table 3.8 provides a description of each function
and its associated range, step size, and default value.
To access a function perform the following steps:
1. Connect the HHC’s cable to the communications port on
the front of the SAMMS-LV device.
2. Locate the desired function using the (F)unction and UP and
DOWN keys.
3. Then locate and follow the steps provided with the function
you wish to perform.
3.28.1 Program Mode/Passwords
To access the functions in program mode, the user is required
to enter a password. The default password is “0000,” and may
be changed at any time. To enter the password and have
access to program mode:
1. Press and hold the (F)unction key for several seconds until
“dISP” is displayed.
2. Press the UP or DOWN key to change to the program mode.
The display reads “Prog.”
3. Press the ENTER key, and the display shows “HHH0,” the
prompt for entering the password.
4. Press the UP or DOWN key to select the first digit, then press
ENTER. The display reads “HH0-.”
5. Continue to select password digits and press ENTER to
enter each digit.
6. After correctly entering the four digit password, the display
reads “- - - -,” and pressing ENTER gives access to the
functions in program mode.
7. If the password was entered incorrectly, the display will read
“Err.” Press the ENTER key to return to program mode and
try again.
Table 3.8 Motor control and protection functions (page 3 of 3)