Samsung SRP-350 - Manual (Page 27)

52
Control codes Hexadecimal codes Function
1C Control peripheral device #1
immediately.
19 Control peripheral device #2
immediately
1A Control peripheral device #2
immediately
“d” n 1B 64 n Partial-cut command to the
auto cutter.
18 Cancel last line & Initialize
printer immediately
13 Deselect printer
11 Set select mode
1E Beep the buzzer
“@” 1B 40 Initialize printer
05 Inquiry (Status inquiry)
04 Near end status inquiry
“?” 1B 3F 0A 00 Reset printer hardware
(Perform test print)
“8” n1 n2 1B 38 n1 n2 Registers a logo pattern
“9” n1 n2 1B 39 n1 n2 Prints a logo pattern
53
B. Connectors
䧎 When the Dip Switch is “ON” on the Serial Interface Board,
DTR and RTS are connected each other.
SRP-350/SRP-350S Connector
( Serial Interface )
SRP-350P Connector
( Parallel Interface )
SRP-350U Connector
( USB Interface )
Interface Connector Drawer kick-out
connector
Power supply
connector
RS-232 Ver.2 ON
Interface Connector Drawer kick-out
connector
Power supply
connector
PARALLEL Ver.2
USB
USB Connector Drawer kick-out
connector
Power supply
connector
Ver.2