Samsung SRP-350 User Manual
Page 22
42
GS B n
[Name]
[Format]
[Range]
[Description]
Turn white/black reverse printing mode on/off.
ASCII GS B n
Hex 1D 42 n
Decimal 29 66 n
0 ≤n ≤255
Turns on or off white/black reverse printing mode.
* When the LSB is 0, white/black reverse printing mode is turned off.
* When the LSB is 1, white/black reverse printing mode is turned on.
GS H n
[Name]
[Format]
[Description]
Select printing position of HRI characters.
ASCII GS B n
Hex 1D 48 n
Decimal 29 72 n
Selects the printing position of HRI characters when printing a bar code.
n selects the printing position as follows :
n
Printing position
0, 48
Not printed.
1, 49
Above bar code.
2, 50
Below bar code.
3, 51
Both above and below the bar code.
* HRI indicates Human Readable Interpretation.
GS I n
[Name]
[Format]
[Range]
[Description]
Transmit printer ID.
ASCII GS I n
Hex 1D 49 n
Decimal 29 73 n
1 ≤n ≤3, 49 ≤n ≤51
Transmits the printer ID specified by n as follows :
n
Printer ID
Specification
ID (hexadecimal)
1, 49
Printer model ID
SRP-350 series
20
2, 50
Type ID
02
3, 51
ROM version ID
Depends on ROM version
02
43
GS L nL nH
[Name]
[Format]
[Range]
[Description]
Set left margin.
ASCII GS L nL nH
Hex 1D 4C nL nH
Decimal 29 76 nL nH
0 ≤nL ≤255, 0 ≤nH ≤255
Sets the left margin using nL and nH.
* The left margin is set to
[(nL + nH ×256) ×horizontal motion unit] inches.
GS P x y
[Name]
[Format]
[Range]
[Description]
Set horizontal and vertical motion units.
ASCII GS P
x y
Hex 1D 50 x y
Decimal 29 80 x y
0 ≤x ≤255, 0 ≤y ≤255
Sets the horizontal and vertical motion units to approximately 25.4/x mm
{1/x inch and } and approximately 25.4/y mm {1/y inches }, respectively.
When x and y are set to 0, the default setting of each value is used.
①
GS V m , ② GS V m n
[Name]
[Format]
[Range]
[Description]
Select cut mode and cut paper.
①
ASCII GS V m
Hex
1D 56 m
Decimal 29 86 m
②
ASCII GS V m n
Hex
1D 56 m n
Decimal 29 86 m n
①
m = 1, 49
②
m = 66, 0 ≤n ≤255
Selects a mode for cutting paper and executes paper cutting.
The value of m selects the mode as follows :
m
Print mode
0, 1, 49
Partial cut (one point left uncut)
66
Feeds paper (cutting position + [nX(vertical motion unit)]),
and cuts the paper partially (one point left uncut).