Preparing – Sharp SCL901 User Manual

Page 22

Preparing

Connecting the Power Source

ENGLISH

✤

There are two ways to connect power source.
-

Using the AC Power Adapter : used for indoor recording.

Using the Battery Pack: used for outdoor recording.

To use the AC Power Adapter

1. Connect the AC Power Adapter to the AC cord.

2. Connect the AC cord to a wall socket.

Note: The plug and wall socket type may be

different depending on regional conditions.

3. Connect the other end of the DC cable to DC jack of the

camcorder.

4. To set the camcorder to the CAMERA mode.

a. Hold down the tab of the power switch and push the switch to CAMERA mode.
b. Make sure that the Lens Cap is open.
c. Open the LCD Screen and make sure that the image appears in the LCD Screen.

The LCD Screen is turned on automatically when it’s opened more than 30 degrees.

Note: If the adapter is used next to a TV or the camcorder, it may cause the TV or camcorder to emit noise. Move the adapter away

from the TV, camcorder or the antenna cable.

CAMERA

00732M SCL901 SEA (1-19) 12/26/03 10:40 AM Page 18