State SDV 75 70 NE/PE - Manual (Page 22)

22
Operating instructions are located on front of the water
heater, above or to one side of the gas control valve.
CHECK FOR LEAKS
Be sure to check all your gas pipes for leaks before lighting
your water heater. Use a soapy water solution, not a match
or open flame. Check the factory gas fittings when the main
burner is turned “ON”. Use a soapy water solution for this, too.
Operating (cont’d)
INNER DOOR
OUTER DOOR
Figure 8
Figure 9
Figure 10
WARNING
BEFORE LIGHTING [PROPANE (L.P.) GAS WATER
HEATERS]: Propane (L.P.) gas is heavier than air. Should
there be a leak in the system, the gas will settle near the
ground. Basements or crawl spaces, closets and areas
below ground level will serve as pockets for the accu-
mulation of this gas. Before attempting to operate the
heater or turning a nearby electrical light switch, be
absolutely sure there is no accumulated gas in the area.
Search for odor of gas by sniffing at ground level in the
vicinity of the appliance. If odor is detected, follow the
steps indicated at “For Your Safety” on the cover page
of this manual, then leave the premises.
WARNING
DO NOT force the gas control knob. Use only your
hand to turn it to “ON” or “OFF”. Never use a tool such
as a lever, wrench or pliers. Do not hit or damage the
knob. A damaged knob may result in an explosion and
serious injury. If you have problem turning the knob,
call the gas supplier immediately.
WARNING
AN ODORANT IS ADDED TO THE GAS USED BY
THIS WATER HEATER.
FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use an
phone in your building.
3. Immediately call you gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
4. If you cannot reach your gas supplier, call the fire
department.