Standard Horizon MATRIX GX1280S - Manual (Page 46)

GX1280S Page 46
4. When “REPLY” is selected, press the [CALL/SET] key. And the your
position will be transmitted to the requesting vessel.
5. To exit from position request display, press any key.
7.8.3 Position Send
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
for the MATRIX to send the position.
NOTE
To transmit a Position Send Call, you must setup the MATRIX DSC
Individual / Position Call Directory with the name of the vessel(s) or
person and the MMSI of the DSC radio you wish to send your position
to. To setup this directory refer to section 7.7.1 Setting up the Individual
/ Position Call Directory.
7.8.3.1 Transmitting a DSC Position Send Call
1. Press the [CALL/SET] key. The “DSC OPERA-
TION” menu will appear in the display.
2. Turn the CHANNEL selector knob to select the
“POS SEND.”
3. Press the [CALL/SET] key to select the Individual
directory.
4. Turn the CHANNEL selector knob to select a name
in the directory.
5. Press the [CALL/SET] key to send your position
to the selected vessel.
6. After your position is transmitted, the resend menu
will appear. To send your position again, select
“SEND” and press the [CALL/SET] key.
7. To exit the mode, select “EXIT” and press the
[CALL/SET] key.