Sears 831.159460 - Manual (Page 7)

5. Press the Weight Tube Bumper (64) into the
end of the Weight Tube (63). Insert the Weight
Tube into the stack of Weights (25).
Be sure
that the pins on the Weight Tube are sitting
in the pin grooves in the top Weight.
Lubricate the insides of the holes in the Top
Weight (76). Set the Top Weight on the stack
of Weights (25).
Insert both Weight Guides (62) into the stack
of Weights (25).
Be sure that the indicated
holes in the Weight Guides are at the top.
6. Attach the upper ends of the Weight Guides
(62) to the Top Frame (55) with the 5/16” x 6”
Bolt (60), two 1/2” x 3/4” Spacers (61), and a
5/16” Nylon Locknut (3).
Be sure that the Pulley Bracket (20) is in
front of the right Weight Guide (62) as
shown.
7. Press a 1” x 7/8” Plastic Bushing (75) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place on the Base
(4).
Note: This will be a tight fit. The Plastic
Bushings should fit on each end of the
indicated tube in the Base. Be sure that
the 3 1/2” Pulleys (15) are on the indicated
side.
Lubricate the 3/8” x 8” Bolt (59). Attach the
Press Frame (17) to the Base (4) with the 3/8”
x 8” Bolt and a 3/8” Nylon Locknut (21).
7
5
62
Holes
Lubricate 76
Pin
63
64
61
55
3
60
17
15
59
75
21
4
Tube
62
6
FRAME ASSEMBL
Y
7
ARM ASSEMBL
Y
20
25
Lubricate
Welded
Spacers