Sharp T FOUND AR-M208 - Manual (Page 55)

53
3
S
P
E
C
IAL FUNCTIONS
ERASE
This copier has an edge erase mode and a center erase mode.
● Edge erase can be used to eliminate shadow lines around the edges of copies which appear when
thick paper or a book is used as an original.
● Center erase can be used to eliminate the shadow produced by the bindings of bound documents.
● Edge + center erase can be used together to eliminate both types of shadow lines.
● The standard erase width is 1/2", but can be changed from 1/4" to 1" in 1/4" increments.
★KEY OPERATOR The initial setting of the width for edge erase and center erase can be changed.
See page 10 of the KEY OPERATOR'S GUIDE.
● This feature cannot be used with the 2 in 1 or 4 in 1 feature.
● If the dual page copy feature has been set, center erase and edge + center erase cannot be set.
● This feature cannot be used with non-standard size originals.
1 Place an original on the platen glass or in the document feeder tray.
2 Press the SPECIAL FUNCTION key. Then press the OK key.
● The SPECIAL MODES screen will appear.
3 Use the and keys to select "ERASE" and press the OK key.
● The setting screen for ERASE will appear.
A A A B A B A B A B
Center erase Edge + Center erase Edge erase
Document feeder tray
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
ERASE
OFF
EDGE
CENTER
1/2 inch(1/4~1)
Ar-M208_sec.book 53 ページ ２００２年６月１３日 木曜日 午後２時３７分