Sharp T FOUND AR-M208 - Manual (Page 11)

COPIER INSTALLATION
9
1
GE
T
T
IN
G
S
T
ARTE
D
Be sure to connect the power cord only to a power outlet that meets the specified
voltage and current requirements (See page 97.). Also make certain the outlet is
properly grounded.
NOTE:
Connect the copier to a power outlet which is not used for other electric appliances. If a lighting
fixture is connected to the same outlet, the light may flicker.
Be sure to allow the required space around the machine for servicing and proper
ventilation.
A small amount of ozone is produced within the copier during operation.
The emission level is insufficient to cause any health hazard.
NOTE:
The present recommended long term exposure limit for ozone is 0.1 ppm
(0.2 mg/m
3 ) calculated as an 8 hr. time-weighted average concentration.
However, since the small amount that is emitted may have an
objectionable odor, it is advisable to place the copier in a ventilated area.
12" (30 cm)
Ar-M208_sec.book 9 ページ ２００２年６月１３日 木曜日 午後２時３７分