Samsung SIR-TS360 - Manual (Page 26)

26
CHAPTER 3
Setting up and connecting
3 3
Chapter 3: Setting up and connecting
This chapter explains how to setup and start using your DIRECTV ® HD Receiver.
Contents include:
Before making connections
Jacks and cables
Connecting your DIRECTV
® HD Receiver
Connecting the VCR control cable
Turning on the DIRECTV
® HD Receiver for the first time
Adjusting the satellite dish
Testing your DIRECTV
® HD Receiver
Setting up local networks
Programming local channels
Activating your DIRECTV account
Upgrades
Before making connections
The next step is to make the necessary connections.
Before you begin, please note the following important safety and setup tips.
Protect your components from power surges
Always turn off and unplug your DIRECTV ® HD Receiver, TV, and any other components before connecting or
disconnecting any of the cables.
Position all cables correctly to avoid audio hum or interference
After connecting the components, please run the audio/video cables along the side of the TV set, rather than straight down
the back of the TV.
Make sure that all cables are plugged or screwed tightly into their jacks.
Please make sure that all antennas and cables are properly grounded.
Whenever possible, route audio and video cables away from power cords.
Protect your components from overheating
Do not block ventilation holes in the top of the DIRECTV ® HD Receiver, or any other components.
Make sure to position the components so that air can circulate freely.
If you are positioning the components in a stand or rack, make sure to allow for proper ventilation.
Do not stack components.
If you have a stereo amplifier or receiver as a system component, please place it on the top shelf or top rack so that
hot air rising from it will not flow around other components.
SIR-TS360-CHAPTER 3 11/18/03 9:42 AM Page 26