Sennheiser EW100 G2 - Manual (Page 18)

18
Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera’s flash
mount.
The camera kit consits of:
y 1 perforated plate ¹
y 1 flash mount adapter Ƹ
y 2 square nuts ƹ
̈
Determine where on the perforated plate the flash mount adapter
Ƹ
will
need to be fastened so that the receiver can best be attached to the
camera.
̈
At this position, place a square nut
ƹ
under the perforated plate
¹
.
̈
Fasten the flash mount adapter to the perforated plate using the square
nut.
̈
Remove the belt clip.
̈
Place the perforated plate
¹
onto the rear of the receiver.
̈
Reinsert the belt clip.
SK 100 G2 bodypack transmitter
Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two
1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
̈
Press the two unlocking buttons
ᕩ
and open the battery compartment
cover
ᕨ
.
̈
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
̈
Close the battery compartment. The battery compartment cover
ᕨ
locks
into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries“ on page 17.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser
microphones and instruments (e.g. guitars). DC powering of the condenser
microphones is via the microphone/line input.
̈
Connect the 3.5 mm jack plug
Ƹ
from the microphone/line cable to the
3.5 mm jack socket (MIC/LINE) ᕡ .
̈
Lock the 3.5 mm jack plug by screwing down the coupling ring
ƹ
.
̈
Via the operating menu, adjust the sensitivity of the microphone/line
input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)“ on
page 32).
¹
Ƹ
ƹ
¾ º
º
³ ƹ Ƹ