Sennheiser EW100 G2 - Manual (Page 11)

11
Indications and displays on the receivers
Operation and battery status indication (EK 100 G2 only)
The red LED (LOW BAT/ON)
ᕣ
provides information on the current operating
state of the EK 100 G2:
Red LED lit up: The receiver is switched on and the capacity of the bat-
teries/accupack BA 2015 is sufficient.
Red LED flashing: The batteries are/the accupack BA 2015 is going flat
(LOW BAT)!
In addition, the 4-step battery status display
ብ
on the display panel provides
information on the remaining battery/accupack BA 2015 capacity:
Transmitter battery status indication (EM 100 G2 only)
When the capacity of the transmitter batteries/accupack is so low that the
batteries/accupack must soon be replaced (LOW BAT), the transmitter trans-
mits information on its remaining battery/accupack capacity to the
EM 100 G2 receiver and the transmitter low battery icon
ቧ
starts flashing on
the receiver display panel.
“MUTE” display
The “MUTE” display
ቮ
or
ቨ
appears when
y the RF signal of the received transmitter is too weak,
y the received transmitter has been muted (with the pilot tone transmission
or evaluation activated).
RF signal indication (EK 100 G2 only)
The green LED (RF)
ᕤ
at the front of the EK 100 G2 lights up when an RF sig-
nal is being received.
»
ብ
3 segments: capacity approx. 100 %
2 segments: capacity approx. 70 %
1 segment: capacity approx. 30 %
Battery icon flashing: LOW BAT
ቧ
ቮ
ቨ
EK 100 G2
EM 100 G2
¿