Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 39)

37
FUNCTION Sets the memory switch
CODE “# N, n1 n2 n3 n4”
HEX 1B 23 N 2C n1 n2 n3 n4 0A 00
OUTLINE In order to enable changed memory switch settings, turn the
printer OFF and ON again or send the printer reset command
( “?” ) to the printer. Changed memory
switch settings are stored in EEPROM and these settings will be
stored until they are changed again.
N: Memory switch number (“0,” “1,” “2,” “3,” “4,” “5,” “6”)
n1 n2 n3 n4: Mode settings (For details see below.)
1) N = 0 (Star mode)
n1: Always “0”
n2: Always “0”
Parameter Setting “0” (Default) “1”
n3 Destination Standard Asia Market
n4 FF command *1 See below
*1: Only on printers that have an auto-cutter (SP2520/2560).
*2: Paper feed to cutting position is executed in 1 inch incre-
ments.
N = 0 (ESC/POS mode)
n1: Always “0”
n2: Always “0”
n4: Always “0”
Parameter Setting “0” (Default) “1”
n3 Destination Standard Asia Market
n4 command *1
“0” to “3” Feeds page
“4” to “7” Executes full cut after feeding paper to the cut
position. (*2)
“8” to “B” Feeds page
“C” to “F” Executes partial cut after feeding paper to the cut
position. (*2)