Sirius Satellite Radio PowerConnect XMP3IVKUG0210 - Manual (Page 36)

36
• Pickup Truck:
1 . Use a blunt plastic putty knife or similar blunt tool to lift the rubber
molding around the windshield and tuck the antenna cable underneath it .
2 . Continue tucking the cable underneath the windshield molding around
the windshield to the lowest corner .
3 . At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening . Lift the weather stripping from the opening and tuck
the cable inside it, then replace the weather stripping . Run the cable
inside of the weather stripping to the bottom of the door opening .
4 . Pull the cable out of the weather stripping at the bottom of the door
opening and route it under the carpet toward the dashboard . Coil any
excess cable in a hidden location, such as under the carpet, keeping
it away from any vehicle pedals or controls . Secure the excess cable
with wire ties .
5 . Bring the end of the cable out at the
PowerConnect Vehicle Dock location .
Leave yourself enough cable so you
can easily connect it to the antenna
connector of the dock .
6 . Continue with “Step 5: Connect
the Magnetic Mount Antenna and
PowerConnect Power Adapter” on
page 37 .
Vehicle Installation