Sirius Satellite Radio PowerConnect XMP3IVKUG0210 - Manual (Page 33)

33
• SUV:
1 . Feed the antenna cable underneath the rubber weather
stripping of the rear tailgate window/door and route the cable
along the rear hatch . Lift the weather stripping from the
opening and tuck the cable inside it, then replace the weather
stripping . Pull the cable out from weather stripping and route
it into the cabin under the interior trim . Avoid hinges or gears
that could crimp or cut the cable .
2 . Route the cable through the SUV’s main cabin area under
the interior trim, towards the front of the vehicle . Use a blunt
plastic putty knife or similar blunt tool to lift the plastic trim
just enough to tuck the cable under underneath . Avoid side
airbag locations on back pillars and above the doors . Airbag
locations are marked with “SRS” logos . Be careful not to crimp
or cut the cable .
3 . Bring the cable out from the trim near the front of the cabin
and route it under
the carpet toward the
dashboard or console .
Coil any excess cable in
a hidden location, such
as under the carpet,
keeping it away from
any vehicle pedals
or controls . Secure
the excess cable with
wire ties (purchased
separately) .